Composite

Part:BBa_K3853061

Designed by: Peng Luo   Group: iGEM21_CPU_CHINA   (2021-09-29)


PAOX1-α-factor-his-tag-MnP(S78P)-AOX1 Terminator

Manganese peroxidase (MnP) is the key enzyme in our degrading system. In order to improve its catalyzing ability, we tried rational design. And according to the computational redesign results, 6 mutants were chosen and tested, including their relative enzyme activity and the effect of temperature/pH/organic solvents on them. MnP(S78P) is one of the most promising mutant of MnP. We use BBa_K3853061 to construct the expression system to express and purify the protein.

Biology

Manganese peroxidase (MnP), a glycosylated heme enzyme derived from the white-rot fungus Phanerochaete chrysosporium, can oxidize Mn2+ to Mn3+ under the action of H2O2. Mn3+ can be released outside the enzyme under the action of a chelate such as malonic acid and can oxidise a wide range of phenolic and non-phenolic compounds as a common substrate. The Mn3+-malonic acid chelate can be detected at 469 nm by oxidation of 2,6-dimethyloxyphenol (2,6-DMP), which is also the main enzyme activity detection method for MnP. MnP (S78P) is obtained by mutating the serine at position 78 of wild-type MnP (BBa_K3853000) to proline.

Usage

We mutated the glutamate at position 78 of wild-type MnP to methionine through single-point mutation in order to improve the stability of wild-type MnP. We use BBa_K3853061 to construct the expression system to express and purify the protein.

Characterization

1. Identification

After receiving the synthetic plasmid, we electrotransformed it into Pichia pastoris, and selected monoclonal colonies for colony PCR to verify the successful transformation.

Fig. 1 Agarose gel electrophoresis of PCR products of monoclonal colonies of MnP(S78P). lane 6 for MnP (S78P)

2. Proof of the expression

After the expressed protein was re-dissolved by ammonium sulfate precipitation, it was verified by running gel, and the target protein band was observed by SDS-PAGE (Fig. 2).

Fig. 2 SDS-PAGE of MnP(S78P). lane 6 for MnP (S78P)

3. Enzyme Activity

MnP activity of MnP (S78P) was measured by monitoring the oxidation of 2,6-dimethyloxyphenol (2,6-DMP) at 469 nm. H2O2 concentration were determined using ε240 = 43.6 M-1 cm-1.The reaction mixtures contained 0.4 mM MnSO4, 50 mM sodium malonate (pH 4.5), and 1 mM 2, 6-DMP. For a 96-well plate, 140 μl of the above reaction mixtures and 20 μl enzyme solution were mixed uniformly in advance and then 40 μl 0.1 mM H2O2 were added to initiate reaction. The concentration of 2, 6-DMP's oxidation products, 2, 2', 6, 6'-tetramethoxydibenzo-1, 1'-diquinone, were determined using ε469 = 49.6 mM-1 cm-1. One unit (U) of MnP activity is defined as the amount of enzyme required to convert 1 μM 2, 6-DMP to 2, 2', 6, 6'-tetramethoxydibenzo-1, 1'-diquinone in 1 minute.

As shown in Fig. 3A, the absorbance of the reaction system with MnP (S78P) continued to rise within 1 min, while the absorbance of the control group (without enzyme) did not change. Through UV-visible spectrum of the reaction system after 1 min, the characteristic absorption at 469 nm was observed (Fig. 3B).

Fig. 3 The detection of 2, 2', 6, 6'-tetramethoxydibenzo-1, 1'-diquinone. Mutant 2# refers to MnP (S78P). Control group refers to the reaction system without enzyme. A: The absorbance change at 469 nm in the reaction system within 1 min. B: UV-visible spectrum of the reaction system after 1 min.

4. Thermostability

To evaluate thermal stability, the purified MnP (S78P) were incubated in 20 mM sodium malonate buffer (pH 5.5) with 100 mM NaCl at different temperatures for 6 h (Fig. 4) and the residual enzyme activity were measured and calculated every 2 h. The relative enzyme activity under different temperatures were calculated with the following equation:

As shown in Fig. 4, relative enzyme activity of MnP (S78P) under different incubation temperature displayed distinct characteristics. When the temperature exceeded 50℃, a sharp decline of enzyme activity within 2 h could be observed, but it gradually stabilized in the following 4 hours.

Fig. 4 Thermal stability of MnP (S78P). The initial MnP activity before incubation was set as 100%.

Compared to the MnP without any mutation, MnP (S78P) exhibited higher stability at room temperature after 6 h incubation (Fig. 5).

Fig. 5 Effect of temperature on the stability of MnP (S78P) and MnP after 6 h incubation. The initial MnP activity before incubation was set as 100%. Mutant 2# refers to MnP (S78P). **P < 0.01.


5. pH stability

To evaluate pH stability, the purified MnP (S78P) were incubated in 20 mM sodium malonate buffer with 100 mM NaCl under pH 3-7 for 12 h at room temperature. The relative enzyme activity at different pH conditions were calculated with the following equation:

Compared to the MnP without any mutation, MnP (S78P) exhibited poorer pH stability at pH 3, 5 and 6, while showed higher relative enzyme activity at pH 4 and 7 (Fig. 6). These may be due to the changes in isoelectric point after mutating the serine at position 78 to proline, as 4.5 was the isoelectric point of the wild-type MnP.

Fig. 6 Effect of pH on the stability of MnP (S78P) and MnP after 12 h incubation. The initial MnP activity before incubation was set as 100%. Mutant 8# refers to MnP (S78P). *P <0.05, ***P < 0.001.

References

[1] Wariishi, H., Valli, K. & Gold, M. H. Manganese(II) oxidation by manganese peroxidase from the basidiomycete Phanerochaete chrysosporium. Kinetic mechanism and role of chelators. The Journal of biological chemistry 267, 23688-23695 (1992).


Sequence and Features


Assembly Compatibility:
  • 10
    COMPATIBLE WITH RFC[10]
  • 12
    COMPATIBLE WITH RFC[12]
  • 21
    INCOMPATIBLE WITH RFC[21]
    Illegal XhoI site found at 1111
  • 23
    COMPATIBLE WITH RFC[23]
  • 25
    COMPATIBLE WITH RFC[25]
  • 1000
    COMPATIBLE WITH RFC[1000]


[edit]
Categories
Parameters
None